Shop

WiFi Smart Home Gateway (Compatible with MySensors 2.x)

15.00

PiHome Smart Home Gateway has nRF24L01 to communicate with the nodes and WiFi to connect to your home network to which controller will also be connected. See image below for reference architecture, left side is temperature sensors node with low power wireless (NRF24L01) then in the middle you have PiHome Smart Home Gateway or IOT Gateway that receive temperature readings from sensor node and then right side is your PiHome Smart Heating Controller software installed on raspberry pi that will process/digest these temperature readings and made decision for your heating needs.

Description

All nodes i.e. temperature sensors, boiler controller, zone controller, blinds and lighting controller etc. are scattered around the house that are responsible for controlling light, heating, blinds and other IOT devices serves very little purpose if we can not communicate with them or pass some instructions. Most of the time these devices are battery powered and even ones with main powered don’t communicate through home WiFi and for the battery powered nodes WiFi isn’t the option due to the fact how WiFi works, most of the time these IOT devices are connected through low powered (nRF24L01) trans-receiver but on same time all these IOT nodes need to communicate with controller.

How we can communicate and pass some instructions to these IOT devices/nodes to have control on them? the simple solution that bridge the both worlds (nRF24L01 and WiFi) and to do this we need a device that can communicate to all IOT devices/nodes over low power trans-receiver (nRF24L01) and to our smart home controller over Wi-Fi.

You may have heard about it as Smart Home Gateway or simply IOT Gateway but its same thing so ultimately it communicate with all the nodes and on other side connect with your home automation controller either over WiFi, Ethernet or over serial port.

What is Included in Package

PiHome Smart Home Wi-Fi Gateway comes fully built with nRF24L01 PA LNA to communicate with 2.4GHz nodes and ESP8266 chip module to communicate with your home Wi-Fi.

PiHome Smart Home Gateway comes with web interface to configure your home Wi-Fi settings. you don’t need to upload any sketch.

Compatibility

  • Power: 5v Micro USB 2amp (Power Supply not included)
  • Compatible with MySensors 2.x Library
  • WiFi: b/g/n
  • WiFi Authentication: WEP WPA/WPA2

Additional information

Weight 0.085 kg

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Facebook
Facebook
Pinterest
Pinterest